CENTRAL VACUUM INSTALLATION
Central Vacuum installation can be performed when a new house is being built ( referred to as new construction) or into an existing house (referred to as Retrofit). Retrofits can be more complex and are typically not quoted without a visit. New construction has standardized pricing. Regardless of whether it be new construction or retrofit Central Vacuums installation consists of 2 stages.
Stage One- Run the valves that connect from the house to the CentralVacuum unit. This step is often referred to as the "rough In stage'. This step is usually scheduled as the electrician is finishing up but before the drywall is installed. It is important all plumbing excluding (hot and cold water lines) and heating runs have been completed before starting to run Central Vacuum piping. For existing construction, the timing of this step will vary. time frame to complete this step varies, however, in most cases it is completed within 1 day.
Stage Two(Final Stage)-Install the Central Vacuum unit and inlet valves in the house.In new construction this step is usually down as the appliances are to be installed. In retrofits this step will often happen the same day as step one.time frame to complete this step varies depending on the amount and type of inlet valves to install plus any accessories that have been added. Typically it takes 1.5 hours to 6 hours to complete.
THREE TYPES OF INSTALLATION AVAILABLE
1. Traditional - Traditional inlet valves are strategically placed in the house to allow for maximum coverage with a 30 ft hose 35 ft hoses also available . Pipe is run from the valves to the central vacuum in the shortest and straightest line possible. There are two types of standard inlet valves.
a) LOW VOLTAGE - These valves handle low voltage signals sent sent out by the vacuum unit. When the signal gets back to the machine it will turn on.An electrical outlet is normally installed within 5 feet of these valves. The end user would then plug into the electrical pigtail on the hose to allow the use of an electrical power nozzle to clean carpets.
b) HIGH VOLTAGE - These valves handle the low voltage signal described above plus handle the 120V required by and electrical power nozzle. This allows the end user to configure the hose without the electrical pigtail.Rather the hose is configured with pins that carry the electrical power to run the nozzle. the hose configuration is also known as "Direct connect".
2. Retractable Hose - The ultimate in Central Vacuum systems. No more bulky hose to put away. When finished simply cover the end of the hose and the hose will be retracted into the wall. Inlet valves are strategically placed throughout the house to allow for maximum coverage with the fewest amount of hoses. Hose Hose lengths are 30,40,50 and 60 Ft hoses available but only used if no other option exists. The first portion of pipe that is run from the inlet valve will store the hoses so it must be a minimum length of the hose that is stored inside. the remaining pipe is done so in the straightest and shortest line possible back to the machine.
3.Hybrid - This is a combination of the traditional and retractable hose. The retractable hose installation does not allow for an electrical power nozzle. If an electrical power nozzle is necessary a traditional inlet valves are strategically placed to allow for maximum coverage.
ACCESSORIES
Accessories increase the functionality and convenience of the Central Vacuum
1. Wally Flex gives you quick and easy access to the full portable vacuum which stretches from 2 ft to 13 ft.Great for smaller areas that need frequent pick ups.
2. Vacuum Sweeps are one of the most popular accessories it gets rid of the dustpan and simply sweeps the dirt right into the device.
3. Vroom Retractable Hose 18 or 24 FT - Fits in your kitchen cabinet out of sight the power of a Central Vacuum with the convenience of a retractable hose.
4. Spot By Vroom combine the functionality of a wally flex and the out of site aesthetics of a retractable hose. a great upgrade of the Wally Flex.
5. Vroom Retract Vac Bring the speed and convenience of a hose system to your garage. Comes standard with a 30 ft hose. Surface mounted with may additional tool to choose from makes this the fastest, most convenient way to clean your garage and everything inside it.
Central Vacuum Installation Retrofits
Existing construction presents some unique challenges that make it difficult to have standardized pricing. Pricing for new construction is used as a guideline and each retrofit is quoted on a case by case basis. Schedule us to come on site and perform a free, no obligation consultation.